Troubleshooting Guide - Avanti WBC16Z1B-IS Manual De Instrucciones

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does not operate.
Appliance is not cold enough.
Turns on and off frequently.
Vibrations.
The appliance seems to make too much noise.
The door will not close properly.
Display flashes Error message "HH"
Display flashes Error message "LL"
Display flashes Error message "E9"
PROBLEMS WITH YOUR APPLIANCE?

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is hotter than normal.
A large amount of contents has been added to
the unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Check to assure that the appliance is level.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
appliance.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The appliance is not level.
The appliance is not level.
The gasket is dirty.
The shelves are out of position.
High Temperature Protection
Sensor Short Circuit
See Page 10 for description
Contact the Avanti Service Department
1 - 800 – 220 - 5570
Low Temperature Protection – Open Circuit
See Page 10 for description
Contact the Avanti Service Department
1 - 800 – 220 – 5570
Communication Failure to Power and
Control PCB Boards
Contact the Avanti Service Department
1 - 800 – 220 - 5570
11