Cutting Depth Adjustment; Setting For Bevel Cuts; Plunge Cuts - Mafell KSS 60 cc Manual De Instrucciones

As this is a switch without locking device, the
machine will only run for as long as this switch trigger
lever is pressed.
The built-in electronic system provides for jerk-free
acceleration when the machine is switched on and
under load readjusts the speed to the fixed setting.
In addition, this electronic system adjusts the motor
down in case of overload, i.e. the saw blade will stop.
Switch the machine off then. Then switch the
machine on again and continue sawing at a reduced
feed speed.
The setting wheel 11 (Fig. 2) can be used to adjust
the saw blade speed in a continuously variable
manner between 2700 and 4700
Level
1
2
3
4
5
6
Material groups
- PVC, Plexi, PA
Level: 1 - 6
-
- Hardwood, softwood, plywood
Level: 4 - 6
-
- Coated panel materials
Level: 4 - 6
-
- Soft fibre
Level: 6
-

Switching off: For switching off, release the
switch trigger 10 (Fig. 2). The built-in automatic
brake limits the saw blade slowing time to
approx. 1 - 2 s. The switch-on lock automatically
takes effect again and secures the portable
circular saw against accidental switch-on.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 66 mm.
rpm.
Speed rpm
2700
3100
3500
3900
4300
4700
Proceed as follows to adjust it:

Unfasten the clamping lever 12 (Fig. 1).

Set the cutting depth with the plunge lever 13
(Fig. 1).

The set depth can be read off the scale 14 (Fig.
1). The bevelled edge of the plunge lever serves
as indicator.

Retighten the clamping lever 12 (Fig. 1).
Always set the cutting depth
approx. 2 to 5 mm (1/16 to 3/16 in.)
larger than the material thickness
to be cut.

5.4 Setting for bevel cuts

For bevel cuts, the saw unit can be set to any angle
between 0 and 45°.

In order to incline it, bring the machine into
home position and support it such that it is
possible to tilt the saw unit.

Release the lever 15 (Fig. 1).

Adjust the angle according to the scale on the
segment for tilting.

Retighten the lever 15 (Fig. 1) afterwards.

5.5 Plunge cuts

Danger
Risk of backlash during plunge
cuts! Prior to plunging, place the
machine with the rear edge of its
base plate against a limit stop
fastened on the workpiece. Keep a
firm hold on the machine handle
during plunging and push the saw
lightly forward!

Unfasten the clamping lever 12 (Fig. 1) and put
the machine in the topmost position with plunge
lever 13 (Fig. 1).

Completely open the retractable saw guard with
the pre-feed lever 16 (Fig. 1), so that the
machine can be placed onto the workpiece to be
processed. The saw blade is now freely
suspended above the material and can be
aligned with the marking.
-22-