Crest Audio Pro-LITE 2.0 Manual Del Propietário página 28

Navigation Overview continued
To select an item from the Main Menu, rotate the encoder until
the cursor marks the selection you want. Press the encoder
to navigate to the Sub Menu adjustment screens for that
processing function. When you enter a processing function
Sub Menu, the cursor will appear in the upper left corner of
the screen allowing you to scroll through Sub Menu screens.
Discard and Exit screen
Save and Exit screen
Volume
The current gain settings are always available in the main menu
screen. The dedicated encoders on the front panel are used for
adjustment of the A and B channels in stereo and mono modes.
If the input mode is set to Bridge, the Channel B control is not
active and the volume display shows "na."
Mode
The Pro-LITE ® DSP 2.0 and 3.0 have three input modes, while the Pro-LITE
Stereo Mode screen
Mono Mode screen
To edit a parameter, press the encoder to move the cursor to
the desired parameter on the screen. Turning the encoder then
adjusts that parameter. To scroll to another screen, press the
encoder to return the cursor to the upper left corner of the
screen. You can now scroll through Sub Menu screens.
To reset the DSP and discard edits, select "Discard and Exit"
from the Sub Menu to delete the edits made since entering the
Sub Menu.
The final screen in most process Sub Menus is "Save and Exit."
Press the encoder in this screen to save the edits and return to
the main menu.
Note: Adjustments made are not stored until Save
and Exit is selected and you return to the main
menu. Turning off the amplifier while editing in a Sub
Menu gives the same result as "Discard and Exit."
Volume screen
® DSP 5.0 and 7.5 have two.
Stereo: Inputs A and B go to outputs A and B.
Mono: Input A drives both outputs A and B.
28