Installation - Agio 4000904 Manual De Instrucciones

V
W
X
1.Carefully unpack all items from the box. Place the firepit in the final position. There must be
a minimum of 60.96 cm / 24 inches of clearance from the side of the table top to any
combustible walls.
2. Place the firepit base onto the tabletop. Secure the end of firepit base to the tabletop by
using the 1/4" x 20mm screws and washers that are provided. Then open the door and secure
another side of firepit base to the tabletop. See Figure 3.
3. With the help of another person, turn the table in the upright position. Place the burner pan
protective ring into the firepan/burner assembly as shown in Figure 4. Align the holes in the
burner pan protective ring with the pre-drilled holes on the firepan/burner assembly. Secure
the burner pan protective ring to the firepan/burner assembly by using the two M4 screws as
shown in Figure 4.
FIREPIT BASE
FIREPIT TABLE TOP
BURNER COVER

INSTALLATION

Figure 3
6
FP2914
FP2915
FP2916
Figure 4
1
1
1