Batteries - Agio 4000904 Manual De Instrucciones

ALL the connections. NEVER USE A FLAME TO CHECK FOR GAS LEAKS!
10. Stick the conversion label on the rating plate as shown in Figure 8.
Serial Number _________________
CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of
This appliance has been converted to use Natural Gas. Input 30,000 Btu/hr. (8.8kW)
Max Gas Supply Pressure 7 inch w.c. (1.74 kPa) Min. Gas Supply Pressure 5 inch w.c. (1.24 kPa)
Minimum clearance from combustible constructions: Sides: 60.9 cm/24 inches. Top 182.8 cm/72 inches.
FOR OUTDOOR USE ONLY. If stored indoors, detach and leave cylinder outdoors.
Make sure the control knob is in the "OFF" position. Unscrew the
push button cap on the ignition module located on the control
panel to access the battery compartment. The ignition module
requires one Alkaline AA size battery (1.5V). The negative (-) end
goes in first. See Figure 9.Dispose of battery safely. May explode
or leak if charged or disposed of in fire. Make sure of the polarity.
Mercury and cadmium free.
CAUTIONS: BATTERY INSTRUCTIONS
●Always purchase the correct size and grade of battery most suitable for the intended use.
●Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of different types.
●Clean the battery contacts and also those of the device prior to battery installation.
●Ensure the batteries are installed correctly with regard to polarity (+ and -).
●Remove batteries from equipment which is not to be used for an extended period of time.
●Remove used batteries promptly.
For recycling and disposal of batteries to protect the environment, please check the internet or your local phone directory for
local recycling centers and / or follow local government regulations.
Step5
Metal Rating Plate
Model Number: WT17IL







Figure 8

BATTERIES

9
Conversion Label
Figure 9