Tabla de contenido
Publicidad
FIGURE 1.
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
1. Turn off power at circuit box to avoid possible electric shock.
2. Place mounting bar (B) flush against wall at desired mounting location. Using outside
mounting bar holes as a guide, mark where pilot holes are to be drilled.
NOTE: Mounting bar must be straight for fixture hanging straight.
3. Inset two plastic anchors (G) into the pilot holes (for drywall).
4. Align outside mounting bar holes with plastic anchors (G) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
5. Make an electrical connection by loosening the terminal screws on the terminal block (M)
and inserting the live, neutral and ground terminals.
6. Tighten terminal screws. Make sure there are no stray wires.
7. Position back plate (C) over mounting screws (A) by aligning back plate openings (F) with
mounting screws (A).
8. Secure with cap nuts (H).
9. Place glass (D) into holder (I) and secure with thumb screws (J).
10. Turn power back on at circuit box.
18
M
E
A
B
G
I
J
H
F
D
GS-26-RS17-WH19
Publicidad
Tabla de contenido
