Safety Instructions - Beper P201UTP004 Manual De Instrucciones

Automatic dispenser soap and sanitizing gel Use instructions

Safety instructions

Please read these instructions carefully when using the appliance, to
avoid damage caused by improper use.
Keep these instructions as they can be used in future situations.
If the appliance is transferred to a third party, please include these
instructions with the unit.
Do not attempt to open the container under any circumstances and
do not attempt to repair the appliance by yourself, please consult a
specialist.
Product description Fig. A
1. Top cover
2. Liquid soap insertion hole
3. ON/OFF button
4. Distribution adjustment button
5. Liquid soap nozzle
6. Dispenser body
7. Operating light
8. Battery compartment
Instructions for Use
Insert the batteries into the battery compartment as described in the section "Installing the batteries".
Unscrew the top cover and insert the liquid soap being careful not to fill more than 3/4. It is important that the
soap does not contain lumps or solid parts.
To turn on the dispensing sensor, press the ON / OFF button, the operating light will turn blue (if red, the product
is off).
Place your hands under the soap nozzle, the light will turn blue and start dispensing the soap, in the selected
quantity (see "adjusting distribution quantity") .
If you want to switch off the sensor, press the ON / OFF button and the operating light will turn red.
It is not necessary to turn off the product every time. Steady red light indicates that the product is operating.
Adjusting distribution quantity
This article has three different distribution settings, you can set it according to your needs.
With the dispensing sensor on, press the +/- button. If the operating light flashes 1 time, it means that the mi-
nimum quantity is set. Press the +/- button again and when the light flashes 2 times, it means that the average
quantity has been set, press the button again, the light flashes 3 times, this means that the maximum quantity
has been selected. If you press the button again, the light will flash 1 time, this means that you return to the
minimum quantity setting.
Battery installation
Open the battery compartment by unscrewing the cover counterclockwise and insert the batteries.
Insert 4 "AAA" type batteries and make sure to respect the polarity (+ / _).
Never mix batteries that have different characteristics or of different types.
Attention: replace all batteries at the same time.
Close the battery compartment by screwing the cover clockwise.
If you do not intend to use the appliance for a long period, please remove all the batteries from the battery com-
partment.
Cleaning and maintenance
Do not wash the product under running water but clean with a slightly damp soft cloth.
Do not allow water or other liquids to enter the battery compartment.
6