Operating The Light - Ivoclar Vivadent Bluephase PowerCure Instrucciones De Uso

1.4 Operating the light

Program selection button
To select the desired curing
program
Activating/deactivating polyvision
With the handpiece switched on, the current charging
status is shown on the handpiece as follows:
• No indicators lit up on the handpiece:
Battery sufficiently charged
Curing capacity of minimum 20 minutes in the
High Power program, approx. 15 minutes in the
Turbo program and approx. 8 minutes in the 3sCure
program.
• Battery symbol on the handpiece is flashing orange:
Battery weak
The time/intensity can still be set and a polymerization
time of approx. 6 minutes in the High Power program,
approx. 4 minutes in the Turbo program, or 30 cycles in
the 3sCure program are left. Place the device into the
charging base as soon as possible.
• Battery symbol on the handpiece is flashing orange
and a red "x" is shown:
Battery completely discharged
The light can no longer be called up and the curing time
can no longer be set. However, the handpiece can be
used in the Click & Cure corded operation.
6
The polyvision function is activated by long pressing (>2 s) the program or time selection
button (see 4. Operation). To confirm that polyvision is activated, the handpiece will beep
and vibrate for a short time and the polyvision indicator will light up. Renewed long
pressing of the program or time selection button results in the polyvision function being
deactivated; the handpiece will not vibrate.
Start/stop button
To trigger/abort the
curing process
Time selection button
To select the desired
curing time