Steris AquaShield 00711541 Instrucciones De Uso página 3

4. Remove 1/3 of the sterile water from the full sterile water bottle. This will allow for improved water pressure for better insufflation
and water flow.
5. Open the sterile pouch and remove the AquaShield
contamination.
6. Insert the Water Bottle Tubing into the sterile water bottle and firmly tighten the threaded Lid Cap to ensure a seal.
7. Attach the Endoscope Connector to the endoscope.
8. Leave the Pinch Clamp on the Endoscope Tubing in the open position.
9. Turn Off the Air/Pump on the light source of the Processor.
10. Connect the CO Connection Port / one-way valve on the Lid Cap to the CO
2
11. Turn on the CO source and the insufflator.
2
12. Follow the manufacturer's guidelines for the use of CO
13. Turn on the light source of the processor. Turn OFF the Air/Pump when using CO
14. Prime the air/water channel prior to insertion of the endoscope into a patient. If water pressure is low, check to see that the
Lid Cap is tightly closed. Ensure that all connections are secure.
15. Perform CO insufflation and water flow for lens cleaning as described in the Olympus instruction manuals for air/water valve and
2
the endoscope being used together with a sterile water bottle.
16. If the water bottle needs to be replaced, use proper aseptic technique.
Note: If air is to be resumed, turn OFF CO
After Procedure is completed
Follow the Olympus manufacturer's guidelines for purging the air/water channel system when the procedure is completed

 Close the Pinch Clamp on the Endoscope Tubing and disconnect from the endoscope. This will prevent water from leaking
from the Endoscope Connector.
 Follow the manufacturer's guidelines for turning off the light source, the Air/Pump on the processor and CO
the procedure is completed.
 Ensure that the device is discarded within 24 hours after the package has been opened. A label is provided with the device.
00711541
00711543
Pinch Clamp
Endoscope Connector
00731827 Rev.J
®
system CO . Avoid contact with the Water Bottle Tubing to reduce the risk of
2
source/insufflator and supply tubing.
2
source/insufflator and turn ON the Air/Pump on light source of the processor.
2
supply tubing that is connected to the CO
2
2.
CO Connection Port / one-way valve
2
Lid Cap
Water Bottle Tubing
source.
2
source/insufflator when
2