Holmatro GSP 52 EVO 3 Serie Manual página 44

EN
6.3 During use
6.3.1 Changing the battery pack
The battery pack has a LED indicator that indicates the approximate battery level (the State Of Charge).
No lit LED indication will be shown during the operation of the tool.
CAUTION
• Many cycles in a short time may cause temperature increase above allowed limits. The
battery protection will shut down the battery until the temperature lowers to a value within
allowed limits.
• Using the battery pack at temperatures above 45 °C (113 °F) reduces the life time of the
battery pack.
Refer to Fig. 10.
• Switch off the tool using the on/off switch.
• Remove the battery pack.
• Place a new battery pack on the tool.
• Switch on the tool using the on/off switch.
NOTICE
It is highly recommended to have at least one fully charged spare battery pack available at
all times.
NOTICE
To protect the battery pack, the tool will stop as soon as the battery pack gets empty. It might
happen that at that time the tool is fixated. To remove the tool it is best to replace the battery
pack by a fully charged one. When this is not possible the battery pack can be activated
again by pushing the SOC indicator button. To prevent damaging the battery pack, this can
only be done a limited number of times.
6.3.2 Tool movement
The spreading arms open and close relatively quickly until they encounter resistance. Then the pump
will build up the required pressure for spreading, cutting, pulling or squeezing.
WARNING
Take extreme care during tool movement. Because of the enormous power of the tool parts
of the body can easily be crushed or pinched.
6.3.3 Spreading
CAUTION
Make sure that the spreading tips have been properly attached to the spreading arms.
Initial opening is sufficient
• Close the spreading arms completely.
• Place both spreading tips between the parts to be spread.
• Force the parts apart by opening the spreading arms.
44 916.001.653_003 GSP 52* EVO 3