Holmatro GSP 52 EVO 3 Serie Manual página 50

EN
8.5.5 Accessories
• Check the accessories for damage, dirt and completeness. Replace damaged accessories and
make sure that the accessories are complete.
• Remove dirt with clean running water. Dry the accessories. Apply a thin coat of preservative oil to
the external steel parts.
8.5.6 Lock pins for accessories
• Check the lock pins for the accessories for damage and operation.
• Drip preservative oil through the slits of the lock pins and operate the mechanism by pushing on the
lock pins several times.
• Have the Holmatro Certified Technician repair the lock pins if they are damaged and/or do not work
properly.
8.5.7 Spreading arms and spreading tips
• Check the spreading arms and the spreading tips for damage. Have the Holmatro dealer replace
damaged parts.
8.5.8 Snap rings of hinge pins
See Fig. 11.
• Check that the snap rings of the hinge pins (A) are present and are not damaged.
Have a Holmatro Certified Technician mount a new snap ring if it is missing or damaged.
8.5.9 Hinge pins
See Fig. 11.
• Spray Teflon lubricating oil on and between the moving parts of the hinge pins (A) while the tool is
opening and closing.
WARNING
The hinge pins may not be removed.
8.6 Yearly dealer maintenance
We recommend having the equipment inspected, checked, set and tested once a year by a Holmatro
Certified Technician who has the appropriate knowledge and the necessary tools (see also section 1.7).
The Holmatro dealer can organize the yearly maintenance for you on a contract basis.
8.7 Packaging
In many regulations such as IATA (air), ADR (road) and IMO (sea), Li-Ion battery packs are considered
as dangerous goods. Please make sure that the goods are packed and transported in accordance with
the latest regulations. Consult your Holmatro dealer for detailed instructions.
8.8 Storage
8.8.1 Temporary storage
• Store the tool and the battery pack in a dry and well-ventilated dust-free area.
• Fasten the tool so it can not fall over to prevent oil leaking.
• Check that the on/off switch is OFF.
• Retract the plunger(s) and then open them ± 5 mm, so that the tool can be stored without pressure.
• Apply a thin coat of preservative oil to the external steel parts.
50 916.001.653_003 GSP 52* EVO 3