Operation - Sears CRAFTSMAN PRO Serie Manual Del Operador

Drive Control
Recoil Starter
Grass Catcher
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the drive control to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Drive Controls
The drive controls are located on top of the upper handle and are used to engage
the drive. Squeeze the right, left, or both right and left controls against the upper
handle to engage the drive; release it/them to slow down or stop mower from
propelling.
Cutting Height Adjustment Lever
The cutting height adjustment lever is located above the left rear wheel. To adjust
the cutting height, refer to page 11 in the Assembly Section.
Grass Catcher
The grass catcher, located at the rear of the mower, is used to bag the grass
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Drive Control
Oil Fill Cap/Dipstick
Trail Shield
(Not Shown)
WARNING
Meets ANSI Safety Standards
Blade Control
Cutting Height
Adjustment
Lever
Figure 12
clippings for disposal at another site. Once the bag is full, remove it up through the
handles and empty it before any further mowing.
Deck Wash
Your mower's deck is equipped with a water port on its surface as part of its deck
wash system. Use the deck wash to rinse grass clippings from the deck's underside.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Oil Fill Cap/Dipstick
Refer to the Engine Operator's Manual packed with your mower for detailed oil
filling, checking and changing instructions.
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
12
Deck Wash