Danby Parcel Guard DPG37U Manual Del Propietário página 6

INSTALLATION INSTRUCTIONS
B. Secured through the rear
1. Use a power drill and a 1/4" drill bit to create
holes in the marked locations on the back wall
of the Parcel Guard.
2. There must be 3" of space between the wall
and the Parcel Guard to ensure the power cord
does not get pinched. It is recommended to use
2 blocks of 2" x 4" wood as a spacer. Attach
the spacer to the wall at the height of the screw
holes in the back of the cabinet.
3. Place the Parcel Guard against the spacer that it
will be secured to.
4. Use a pen or pencil to mark the hole locations
through the drilled holes.
5. Move the Parcel Guard out of the way and then
use a power drill and a 1/4" drill bit to create
guide holes for the bolts or screws, at least 2.5"
deep for wood screws.
6. Replace the Parcel Guard and insert the wood
screws with washers into the holes. Use a
wrench to tighten the wood screw.
OPERATING INSTRUCTIONS
RECEIVING MAIL
Mail can be delivered into the top door, which will
then drop down into the secure lower compartment.
Place the Parcel Guard at or near the doorstep that
deliveries are usually sent to.
When placing an order online, indicate in the
special notes fi eld that the delivery should be placed
into your Parcel Guard.
Deliveries can be placed into the top door or into
the bottom door using the app or the manual
override to unlock the bottom door.
RETRIEVING MAIL
To retrieve mail that has been delivered, use either
the app or the manual override to unlock the bottom
door and remove the delivery.
OUTGOING MAIL
Use the provided outgoing mail strap to attach any
outgoing mail to the inside of the top door.
Place the signal fl ag in the upright position to tell
the mail carrier that there is outgoing mail in the top
compartment.
RETURNING PURCHASES
Use the app to create a unique barcode that can be
sent by text or email to the mail carrier.
Place the package to be returned in the bottom
compartment.
The mail carrier will use the barcode to open the
lower compartment and retrieve the outgoing
package.
5