Pump Removal Instructions For Troubleshooting; Rotor Inspection And Replacement Instructions - Polygroup RP800 Manual Del Propietário

PUMP REMOVAL INSTRUCTIONS FOR TROUBLESHOOTING

1.
First turn off the pump and unplug the main power cord of the system. Now remove the RF Diverter Fitting
Return Fitting with the RF lug P
2 5
(REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER)
2. Slowly unscrew the Vent Screw
3. Remove the Seal Top Retainer
tablets left inside the core section of the filter.
4. Loosen all four Hose Clamps
14
5. Reach down inside the Filter Pump Canister
the Volute Housing Inlet. Pull up on the Pump Retaining Nut to remove it and place it in a safe place for reassembly later. (see image below)
6. Now that the Pump is free from the Filter Pump Canister
Motor
Assembly
(Pump)

ROTOR INSPECTION AND REPLACEMENT INSTRUCTIONS

Once the Pump has been removed from the Filter Pump Canister
Please refer to the Motor Assembly Illustration on PAGE 16 for your specific pump size to replace the Rotor Assembly
(REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER)
1. Carefully remove the Phillips Head Screws
2. Remove the Volute Housing Remove the Volute Housing
3. Now carefully remove the Rotor Assembly
separately.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
Now thread the Water Cap
.
21
from the Seal Top allowing the filter system to depressurize.
11 9
by turning counter-clockwise to unscrew. Remove the Seal T
10
, remove the Suction and Return Hoses
and loosen the Pump Retaining Nut
, remove the pump from the bottom.
Volute
Housing
Outlet
, turning counterclockwise, from the Volute Housing
. Then remove the Pump Gasket
. Please be careful as the Rotor Assembly has multiple parts that may come out
MST. Extended operating days and hours during peak season requirements.
onto the Suction Fitting and hand tighten it only!
20 16
op
9
, and allow water to drain out.
12 13
by turning counterclockwise until the Pump Retaining Nut comes off
Pump
you are ready to inspect or replace your Rotor Assembly
.
OWNER'S MANUAL
from the Return Fitting (RF) and then plug the
28
. Remove the Filter Cartridge and remove any chlorine
15
7
Volute
Housing
Inlet
1-6
.
using a screwdriver.
8
.
15