Publicidad
Idiomas disponibles
Idiomas disponibles
F
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. ollo
1 Press the
button ¹ and then the TIMER key
The TIMER lamp
2 Use the adjustment keys
Use the key on the left ( hour) to set the hours and the key on the right
( min.) to set the minutes (interval of 5 minutes).
3 After appro imately 10 seconds the -digit
TIMER lamp
activated ( ig. H).
4 The timer will ensure that the room will have been heated to approximately
the re uired temperature at the set time.
!
When you want to switch off the heater and ignite it again with the timer, all you
have to do is press the TIMER key (refer to Section G).
Press the
button ¹ once to clear the timer setting.
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater:
1
Press the
button ¹. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2 Press the TIMER key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the re uired time
the adjustment keys
H
THE INFORMATION DISPLAY
The information display ¸ not only serves as an indicator of the (set) time and
temperature (Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE
INFORMATION
e - 0
Temperature
f - 0
Po er interrupted.
e - 1
aulty thermostat.
f - 1
aulty burner thermistor.
e - 2
Starting problems.
Re-ignite the heater immediately after
e - 23
extinguishing.
e - 5
Tipping-over protection.
e - 6
Poor burning.
and the -digit ¸ will start blinking.
to set the time at which the heater must ignite.
will light up, indicating that the timer function has been
, when you want to switch off the heater and ignite it
(refer to Section F).
ithin the heater too high.
the procedure belo :
immediately after that.
ill sho
CLOCK again and the
WHAT TO DO
Cool-do n and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Wait for appro . 30 sec.
and re-ignite after inserting
the plug again.
Re-ignite the heater.
Contact your dealer.
H: The TIMER indicator
light indicates that the
timer function has been
switched on.
ith
In case of any
malfunctioning the
information display will
tell you what is the
matter.
4
7
Publicidad
