AMETEK Programmable Power Sorensen XPH Serie Manual Del Usuario página 6

Transient Response:
Temperature Coefficient:
Status Indication:
METER SPECIFICATIONS (Main Outputs)
Meter Types:
Meter Resolutions:
Meter Accuracies:
AUXILIARY LOGIC OUTPUT (XPH 35-4T only)
Voltage:
Meter Voltage Accuracy:
Current Limit:
Output Protection:
Load Regulation:
Line Regulation:
Ripple & Noise
(20MHz bandwidth):
Transient Response:
Temperature Coefficient:
Status Indication:
GENERAL
AC Input:
Power Consumption:
Operating Range:
Storage Range:
Environmental:
Safety:
EMC:
Size:
Weight:
4
<200µs to within 50mV of set level for 90% load change.
Typically <100ppm/°C.
Output on lamp. Constant current mode lamp.
Dual 3 digit meters with 14mm (0·56") LEDs. Reading rate 4 Hz.
100mV, 10mA.
Voltage 0.3% of reading ± 1 digit,
Current 0.6% of reading ± 1 digit.
Variable <1·5V to >5V by front panel control.
0·3% ± 1 digit
5A minimum.
Output will withstand up to 7V forward voltage.
Diode clamp reverse protection for currents up to 3A.
<0·5% for 90% load change.
<0·1% for 10% line voltage change.
Typically <2mVrms, <10mVpk-pk (CV mode).
Typically <200µs to within 50mV of set level for 90% load change.
Typically <100ppm/ºC.
UNREG lamp.
110V - 240V AC ± 10%, 50/60Hz. Installation Category II.
500VA max.
+5ºC to +40ºC, 20% to 80% RH.
−40ºC to + 70ºC.
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010-1.
Complies with EN61326.
260 x 160 x 320mm (WxHxD).
4·3kg