Optional Accessories - Arbortech PCH.FG.600.40 Manual De Instrucciones

Ocultar thumbs

Contenido

página de 45

/ 45
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

b. Always wear correct safety clothing, including ear, eye

protective gloves and lung protection.

c. Follow local government safety regulations when

working on materials treated with or containing toxic

substances.

d. Do not use this tool in wet conditions or in the presence

of flammable liquids and gases.

e. Check tool before using. Test run the power tool with no

load prior to use. Do not use damaged tools.

f. Apply lubricant oil the Power Chisel every 15 minutes of

use. As shown in Fig. D, apply lubricant from the Oil

bottle into the oil port.

g. Do no exert excessive pressure. The excessive pressure

will overheat the chisel and the cam leading to

premature failure.

SWITCHING ON AND OFF

This power tool is equipped with lock-on switch. To start the

power tool, push the On/Off Switch (5) forwards (Fig. B) then

press it down at the front until it latches. To switch off the

tool briefly push down the back of the On/Off Switch and

release.

⚠

WARNING: The tool includes a restart prevention

feature, which prevents uncontrolled restarting after an

interruption to the power supply. To resume operation,

switch the tool to the off position and start the machine

again.

This power tool has variable speed control. Ensure an

appropriate speed setting is selected for the application

from the table below.

Speed

Application

Setting

5 – 6

Chiselling of wood - general

4 – 5

Medium chiselling of wood like materials for

unique applications

1 – 4

Lighter chiselling of wood like materials for

detailed applications

Support and secure the workpiece to prevent movement

and loss of control. Operate the tool using two hands for

better control. Ensure the tool is running before contacting

the work piece. Approach the workpiece with caution to

avoid sudden hammering and gently push against it. If the

applied pressure is too light, the chisel will not hammer. Hold

the grinder at an angle of 25° as shown in Fig. E. Move the

tool in the desired direction, keeping contact between the

workpiece and the chisel.

⚠

WARNING: Do not use the chisels as a lever to break out

wood.

MAINTENANCE

⚠

WARNING: Before any adjustment, cleaning or

maintenance work on the machine itself, disconnect from

the power supply.

Inspect the Chisel Arm Base (7) is securely mounted. If loose,

ensure the arm is fully inserted and seated correctly on the

grinder then retighten the Clamping Bolt (6).

Inspect the accessories for damage and maintain them as

specified in their user manual.

For your safety and the reliability of this product, all

electrical repair and maintenance of the internal parts,

other than maintaining accessories and attachments,

should be carried out by Arbortech authorised service

centres.

CHISEL SHARPENING

Remove the chisel from the unit. Use conventional chisel

sharpening methods. Maintain the angle on the cutting

edge. Check the Arbortech website for detailed sharpening

instructions.

CLEANING THE AIR VENTS AND SWITCH

Regularly check to see if any dust or foreign matter has

entered the air vents, or under the On/Off switch. If so, use

a soft brush to remove any accumulated dust to clean the air

vents and switch.

INSPECTION AND WEAR

To inspect the tool for wear, insert a chisel into the chisel

arm. Ensure that the chisel is firmly located and cannot move

within the Chisel Arm. If the chisel has excessive side

movement, internal guides may be worn and should be

replaced by an Arbortech authorised service centre.

If the chiselling impact performance has decreased, inspect

the chisel shaft for excessive wear or replace the chisel. If the

chisel wear is acceptable, an internal cam may be worn and

should be replaced by an Arbortech authorised service

centre.