Descargar Imprimir esta página

Silver King SKF48AG/CFRL Manual Tecnico página 2

Congeladores de respiracion frontal

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable
equipment in the industry today. Please read this manual and the accompanying warranty information before operating your
new Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to examine and test for possible damage following the instructions
printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly
present a claim for any evidence of mishandling. Save all packaging materials if a claim must be filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using
a warm, mild soapy water solution and a sponge or soft cloth. Rinse afterward with clean water and wipe dry. Do not use
chlorinated cleaners.
Location:
When locating your new Silver King unit, convenience and accessibility are important considerations, but the following
installation guidelines must be observed;
• Always avoid locating the unit adjacent to an oven, heating element or hot air source which could adversely affect the
performance of the unit.
• The unit must be level.
• For proper ventilation, the bottom front of the unit must not be obstructed.
Legs/Casters:
Models without a base come with Legs or Casters. To install them, tilt the unit and thread the Legs or Casters into the four
Rivnuts in the bottom of the cabinet. Make sure that they are installed tightly to prevent future thread wear.
Condenser Filter Screen
On models without a base, the Condenser Filter Screen, Screen Pull and Filter Guides are packaged inside the cabinet. The
instructions for installing these parts are included in this technical manual. On models with a base, the Condenser Filter
Screen is factory mounted behind the Base Grill. Remove the Base Grill and ensure that the Condenser Filter Screen is in
place. Do not operate the unit without the filter screen installed!
Shelves:
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with the "tang" go on the
rear Pilasters. This shelf system allows for easy adjustment to suit your needs.
Door Adjustment and Swing:
Should the door ever require straightening, loosen the screws on the hinges, square the door with the cabinet and retighten
the screws.
The mounting of the door is easily reversible on single door units should space or convenience require that you do so. Simply
remove the screws holding the hinges, rotate the door 180 degrees and relocate the hinges on the side opposite their original
location.
TECHNICAL MANUAL
SILVER KING FRONT BREATHING FREEZER
MODELS SKF48AG/CFRL
1

Publicidad

loading