Publicidad
3"-4"
LACAVA LLC
7. If there is a faucet being installed on the deck of the
pedestal, install the faucet following the manufacturer's
instructions, and test for any leaks.
8. Place the lavatory with already assembled drain over
the pedestal, slowly align and place the tailpipe well into
the p-trap, about 3-4" to seal sewer gases. Tighten well
and test for leaks.
9. Slowly push the p-trap bottom pipe into the PVC pipe
8
in the floor, until the lavatory comes in contact with
the pedestal.
10. Very carefully align the 3 brackets attached underneath
the lip of the lavatory with the 3 notches on the pedestal.
11. Slowly push the lavatory down flush with the pedestal
and turn a couple of inches to lock in place.
HANDLE WITH CARE TO AVOID DAMAGES AND SCRATCHES
9
TO THE SURFACE OF THE LAVATORY AND THE PEDESTAL.
6
11
10
Publicidad
