Mafell KSS 60 cc Traducción Del Manual De Instrucciones Original página 27

Defect
Saw blade jams as the machine is
advanced
Burn marks on the cut surfaces
Chip ejection blocked
Cause
Feed rate too fast
Blunt saw blade
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
The saw blade used is unsuitable
for the task or blunt
Wood is too damp
Extended operation
extraction
-27-
Elimination
Reduce feed speed
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Use parallel stop
Straighten the surface
Replace saw blade
without Connect to an external extraction,
e.g. portable dust extractor