Marq HAZE700 Guia Del Usuario página 5

Operation
Fluid
We recommend using a high-quality, water-based haze fluid with Haze 700. You can purchase this
from a local or online retailer.
Important: Using non-water-based fluids with this product will void its warranty.
Setup
Important: Use in well ventilated environment to prevent excessive concentration of vapor. Do not
use this product as a space heater or humidifier.
Any item not listed in
1. After unpacking the box, unscrew and remove the cap at the top of the tank.
2. Fill the tank with a water-based haze fluid (described above).
3. Screw the cap back onto the top of the tank so it is secure. Make sure the tube (that passes
through the cap) is inserted as far into the tank as possible.
4. Connect the remote control to the rear panel of Haze 700.
5. Connect Haze 700 to a power outlet.
6. On the remote control, set the Power Switch to the On position. The Power light will illuminate,
and Haze 700 will begin warming up.
Important: If the environment is significantly colder than the temperature of Haze 700, you may
need to wait for it to adjust to the ambient temperature.
7. Wait for 2–3 minutes for Haze 700 to warm up. During this time, do not press any buttons on the
remote control. The Ready light on the remote control will illuminate when it is ready to use.
Introduction > Box Contents is sold separately.
5