Marq HAZE700 Guia Del Usuario página 6

Usage
If you are using the remote control:
When the Ready light on the remote control is on, turn the Output Volume knob to control the
amount of haze.
If you are using the rear panel controls only (no remote control):
To set the amount of haze, press Volume. When H and 3 numbers appear, use the Up/Down
buttons to set a new value: 001 (low) to 005 (high).
When you are done using Haze 700, do not power it off immediately. Instead, turn the Output
Volume knob completely counterclockwise, and then wait for about 1 minute. This will allow the
heater to clear itself of any remaining fluid.
Important: Depending on the amount of haze generated, this product may set off smoke detectors.
In certain environments after prolonged use, the haze produced may leave a slippery residue on
floors and other surfaces.
Cleaning
We recommend cleaning it after each use to prevent eventual build-up or blockages, which can
result in poor performance, overheating, and damage.
After each time you use Haze 700, turn the Output knob on the remote control completely
counterclockwise, and then wait for 1–2 minutes. This will allow the heater to clear itself of any
remaining fluid.
We also recommend wiping its metal housing with a soft, clean cloth. Remember to disconnect the
power cord from its power outlet first.
Important: Do not clean Haze 700 using solvents or harsh detergents.
You may also use compressed air and soft brush or a vacuum to remove dust from the external
vents or internal parts.
6