Electronics On / Off Switch - Campbell Hausfeld CHN70700 Manual De Instrucciones Y Lista De Piezas

Clavadora/ grapadora 2 en 1 de 5,08 cm (2 pulg.)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions and Parts Manual
Pre-Operation (Continued)
5. Depress the WCE against the work surface without pulling the trigger (See
Figure 16). The nailer MUST NOT OPERATE. Do not use the tool if it operates
without pulling the trigger. Personal injury may result.
6. Remove nailer from work surface. The WCE must return to its original down
position. Pull the trigger (See Figure 17). The nailer MUST NOT OPERATE. Do not
use the tool if it operates while lifted from the work surface. Personal injury may
result.
7. Pull the trigger and depress the WCE against the work surface. The nailer MUST
OPERATE when in bump mode. The nailer MUST NOT OPERATE if in sequential
mode.
8. Depress the WCE against work surface. Pull the trigger. The nailer MUST OPERATE.
9. Switch nailer into the other Mode as described in Operational Modes section and
repeat.
IMPORTANT: Repeat steps one through nine with tool in Safety Lockout Mode. Tool
SHOULD NOT operate at any step. If tool does operate while in Safety Lockout Mode,
contact Campbell Hausfeld for technical support.

eleCtroNICS oN / oFF SWItCH

Located under the top of the rubber grip is an ON/ OFF switch for the tool's electronic
functions, low nail indicator LEDs, and nail placement laser.
To utilize the function, grip the tool by the handle, depressing the switch. Hold the
switch firmly for continuous, uninterrupted function. Power is maintained for 5-10
seconds after releasing the switch. This extra time is helpful when adjusting your grip
on the tool which may temporarily undepress the switch.
Figure 16
Figure 17
Switch
Figure 18 - electronic oN/oFF Switch
www.chpower.com
CHN70700
Work Surface
Work Surface
13

Publicidad

Tabla de contenido
loading

Tabla de contenido