KEUCO Royal Reflex.2 Serie Manual De Instrucciones De Uso página 3

US
Read all instructions before using or installing this product.
Technical data
– Supply voltage:
– Required electrical outlet:
– Max. power consumption:
Prod. No.:
14296 001550:
– Degree of protection:
– Ambient conditions:
Operating temperature
Storage temperature
– Luminous color
Mounting dimensions, see page 8.
Included items, refer to picture 1 on page 9.
WARNING - GROUNDING
INSTRUCTIONS
This product must be connected to a grounded me-
tal, permanent wiring system, or an equiment-groun-
ding conductor must be run with the circuit con-
ductors and connected to the equipment-grounding
terminal or lead on the product.
Wiring diagram, refer to picture 2 on page 9
The product can be operated in two ways.
Operating mode 1 (condition as supplied):
Light on/off on rotary dimmer of the product
(automatically off after power reinstated).
Operating mode 2:
Light on/off on external light switch (automatically
on after power reinstated).
To toggle the operating mode, press and hold
the rotary dimmer 15 seconds while the light is
switched off. The light turns on briefl y to confi rm
the change to the operating mode.
Lighting modes
The product has 3 different lighting modes.
Mode 1: Front illumination
Mode 2: Washbasin illumination
Mode 3: Front and washbasin illumination
Press the rotary dimmer for at least one second
to change the lighting modes.
120 V AC / 50/60 Hz
15 A / 1800 VA
Width Weight Light
19-11/16" 18.1 lb
NEMA 1
32° – 113° F
-40° – 158° F
3000 Kelvin
Installation
Before installation check whether the fastening mate-
rials included are suitable for the anchoring base. The
fastening materials are suitable exclusively for stud walls
with timber constructions or for drywall constructions with
timber wood reinforcement.
45 W
• Mark the wall bracket position, see fi gure 3 on
page 9.
• Mount the wall brackets to the wall, see fi gure 4.
• Connect the light mirror to the power supply,
see fi gure 5 on page 10.
• Remove the adhesive cover from the light mirror
fi xation, see fi gure 6.
• Hang the light mirror on the wall from above,
see fi gure 7.
• Press the light mirror to the light mirror fi xation,
see fi gure 8.
Operation, refer to picture 9 on page 10
Note: When switching off the lights, the type of
lightning and its intensity are saved and will be
the same after switching on the lights again.
Replacement parts with order numbers, see page 11.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions and
Warranty Card.
Disposal instructions
This category of device does not belong in
the domestic waste, but must be disposed of
separately in accordance with the relevant local
national regulations.
3