Installation And Start-Up - Abus SHRM10000 Manual De Instrucciones

Where smoke alarm devices should not be installed






Installation and start-up

Take the following steps in the specified order to install the detector on the
ceiling.
1. Loosen the device from the
mounting bracket by turning it
anticlockwise.
2. Remove the battery insulating strip
to electrify the device.
Outside (use only in closed rooms)
In rooms in which the alarm could be triggered by
disturbance variables (steam, condensation, "normal"
smoke, vapour, dust, dirt or grease)
Next to an air duct or similar ventilation opening (draughts)
In areas in which the temperature can fall below 0°C or
rise to over 40°C
On unstable surfaces with designs that render them
unsuitable for installation
15