Troubleshooting - Bosch Sensixx'x DA50 SensorSecure Instrucciones De Uso

Trouble shooting
problem probable cause
The iron does not 1. Temperature control (12) set to
heat up.
2. The "SensorSecure" system has
"SensorSecure" 1. The "SensorSecure" system has
indicator lamp (15)
flashes.
The clothes tend 1. The temperature is too high.
to stick.
Water drips out of 1. Temperature control (12) setting
the soleplate (7)
together with
steam. 2. Steam regulator (3) is set too
3. You have pressed the shot of
Steam does not
1. Steam regulator (3) is set to
come out.
2. The temperature is too low.
Smoke comes out 1. This may be caused by the
when connecting
the iron for the first
time.
Deposits come out 1. Traces of lime scale are coming
through the holes
in the soleplate
(7).
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
minimum.
been activated. The iron is set to
stand-by.
been activated. The iron is set to
stand-by.
is too low.
high in conjunction with a low
temperature.
steam button (2) repeatedly
without waiting for 5 seconds
between each press.
position.
Anti-drip system is activated.
lubrication of some of the internal
parts.
out of the steam chamber.
Solution
1. Turn to a higher position.
2. Grip the handle of the iron to re-start it.
1. Grip the handle of the iron to re-start it.
1. Turn the temperature control (12) down
and wait until the iron has cooled down.
1. Turn the temperature control to a higher
setting (between "••" and "max") and wait
until the pilot light (13) goes out.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press of
the shot of steam button.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if compatible
with the fabric.
1. This is normal and will stop after a few
minutes.
1. Carry out a cleaning cycle (see
"Calc'nClean" section).
17
BOS CH