Warranty - Nolan N-com x Serie Manual Del Usario

18

WARRANTY

Certification and Safety Approvals - FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antennae
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure compliance. The antenna used for this transmitter must not transmit
simultaneously with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.
When equipped, the distance between antenna and one's head surface is 30.63mm. EUT is marketed without helmet, so when the
EUT is mounted with helmet, it has to be to maintain a distance of 30.63 mm from one's headsurface.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user's
authority to operate the equipment.
Industry Canada (IC) Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this
device may not cause interference and 2) this device must accept any interference, including interference that may cause
undesired operation of device.
This class B digital apparatus complies with Canadian ICES-003.
IC Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
When equipped, the distance between antenna and one's head surface is 38.2 / 34.5 mm. EUT is marketed without helmet, so
when the EUT is mounted with helmet, it has to be to maintain a distance of 38.2 / 34.5 mm from one's headsurface.
Model: B601 X
PMN: N-Com B601 X
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
FOR USA AND CANADA MARKET ONLY: WARRANTY
With this WARRANTY CERTIFICATE, Nolangroup warrants to the purchaser that the product, at the time of purchase, is free from
defects in materials and workmanship.
We kindly ask you to:
•
Read the warnings for safety and proper use.
•
Read the warranty terms and conditions.
•
Keep the original purchase receipt. This receipt must be presented in case of repairs under warranty. In these cases, the
product must be sent to the dealer where the purchase was made.
18.1 Warranty coverage and validity
If any defect covered by this warranty certificate is detected within the period specified for the country of purchase (see table at
the bottom of this leaflet) from the date of purchase shown on the receipt, Nolangroup will repair or replace the defective
FCC ID: IC:
Y6MNCOM20 9455A-NCOM20
R-NZ
23