HAMPTON BAY HD38864 Guía De Uso Y Cuidado

Please read and save these instructions
PACKAGE CONTENTS
Assembly and Installation
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: Safe for outdoor operation
WARNING: Do not operate the luminaire fitting with a missing or damaged lens
or bulb protector.
WARNING: Install in accordance with all local codes and ordinances.
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
ETL LISTED UNDER MODEL # U000-1711
1
Attaching and installing the light
WARNING: Never push the fixture into the ground by the lamp body (A) or use a
hammer to insert the spike (C) into the ground.
q Carefully remove the fixture from its protective packaging.
q Attach spike (C), post (B) and head (A) together by turning them
clockwise.
B
C
B
A
E
C
D
A
LOW VOLTAGE LED TIER LIGHT
Part Description
A Head
B Post
Spike
C
D Connector
E Plastic diffuser
2
Connecting the wires
WARNING: The wire connector (D) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
CAUTION: The wire from the low voltage power unit shall be 12-16 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light fitting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6" (15.24 cm).
• Do not submerge fixture in water.
q Place the wire connector (D) on opposite sides of the low voltage
cable (not included) where the fixture will be located.
q Align and fit the main low voltage cable vertically to the slot of the
wire connector (D) as shown.
q Press the wire connector (D) together until fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation
and establish contact. Turn on the power unit. If the light fixture
does not turn on, repeat the previous steps.
q Once the clip-on connector (D) is in place, it is recommended to
wrap it with electrical tape for additional protection.
q CAUTION BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
q After all fixtures are installed, turn on the transformer.
D
Item #1001 492 904
Model #HD38864
Use and Care Guide
Quantity
1
1
1
1
1