Before The First Use - Domo DO7350CH Manual De Instrucciones

PARTS
1. Handle
2. Button for 1250 W
3. Button for 750 W
4. On/off button fan
5. Temperature knob
6. Foot
7. Ventilation opening
8. Fan

BEFORE THE FIRST USE

Remove all the packaging material. In the package, you will find 2 feet and 4
short screws. Attach the feet with the 4 short screws, 2 on each side, as shown
in the illustrations.
USE
The first time you use the appliance, it may emit a slight odour and smoke. This is normal and not harmful.
1. Select the desired power with the 2 upper switches: 1250 W, 750 W, or 2000 W
(both buttons on).
2. Then turn the thermostat. The lights on the switch will illuminate, indicating that
the appliance is warming up. When the temperature is reached, the lights will go
out and the appliance will stop heating. The temperature will drop again and then
the lights will come back on. This keeps the temperature constant.
3. To spread the heat further into the room, turn on the fan.
You can also use this function without turning on the heating modes. Note: the thermostat must be
turned to the maximum setting for this purpose.
SAFETY DEVICES
· This heater is protected with an overheat protection that switches off the heater automatically in case
of overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches
off the temperature inside when the appliance exceeds the normal running temperature. The heating
element will automatically stop working, the motor will continue to operate, the internal heat shed.
This protective device applies only to the appliance itself and has no influence on room temperature
regulation. In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
22
DO7350CH
8
1
2
3
4
5
6
7
7
1
6