Leotec L-PAD POLAR Manual De Usuario página 25

Memory expand through TF-CARD slot: external T-FLASH card
1.8 Mini USB and USB Host
Mini USB jack: you can use it to connect the computer for data transmission, charging and
external connection USB flash drive
1.9 RESET
Remark: unless unable to shutdown, otherwise don't use the reset, suggest you to shutdown by
normal, or it will easy to damage the machine system.
1.10 DC
Connecting the battery charger.
Attention: ONLY USE THE CHARGER SUPPLIED BY THE MANUFACTURER or ANY
APPROVED BY THE SAME.
First use - Battery management and charge
Before first use, please set the device's battery is fully charged
Just need to connect the adaptor or USB interface, then you can charge
The first two times charging please keep about 6 hours, after that you just need 4 hours to
charge.
Remark: This tablet using Built-in type polymer battery, Charge must be to choose standard
adaptor (Input: AC110~240V 50/60Hz Max：180MA.. Output: DC9.0V/2.0A), this device without
supply DC charging, USB interface can charge, Choose USB interface to charger
During the charging, the battery icon will scroll
When finished charging, battery icon will become green and stop rolling
In order to prolong the service life of the machine, suggest use out battery power before charge it
Remark:
1 If you long time don't to use this Tablet, ,in order to avoid power consumption caused
damage, Please charge/play the battery once a month.
2 After low battery shut down, connect DC adaptor, device will remind low battery, charging,
need to wait some time until the battery is enough power to enter into main menu.
3 Device charging should be in standby status for reach normal charging time.
Because with device and screen consumption, it may cause longer charging time.
2. Connection with PC
Use USB cable to connect device to PC, device will pop up the USB connection window,
clic Turn on USB storage to connect to PC
Once connected click on the USB icon that appears at the bottom right of the screen:
The device enables users to access the screen to activate the USB storage as shown in
the following screen:
25