Surtek RP642A Manual De Usuario Y Garantía página 10

1
7
9
8
13
10 11 12
1. HOSE.
2. COLLECTOR BODY & FAN/MOTOR ASSY.
3. COLLECTOR.
4. BASE PLATE.
5. UPPER BAG SUPPORT.
6. SUPPORTS.
7. INLET.
8. HOSE CONNECTOR.
9. TWO BAGS.
10. GASKET.
11. FOUR CASTERS.
12. NUTS, SCREWS, WASHERS, SPRING WAS-
HERS, AND WRENCH.
13. TWO HOSE CLAMP.
ASSEMBLY
Place the base upside
down and install the 4
caster wheels into the
corresponding holes
and tighten the screws
(Fig.1).
Place the motor housing assembly to the base
and secure it with the screws and nuts pro-
vided. Use the open end wrench. See Figure 2.
Install the fan outlet gasket using the screws
provided. See Figure 3.
10
2
3
4
5
6
Fig.1
Fig.2
Fig.3
Then place and tighten the port hose connec-
tion to motor assembly outlet as shown in Fig-
ure 4.
Now proceed to assemble the support to the
moving base of the collector as shown in figure
5. Then place the collector to the previously
installed supports as shown in figure 6, make
sure the opening is on the motor side.
Fig.5
After having set the
previous assembly
step, place the upper
bag support as shown
in figure 7.
Install one end of the collector hose to the outlet
port of the engine and the other end into the
aperture of the collector, secure both ends with
hose seals provided. See figures 8, 9 and 10.
Fig.8
Fig.9
Fig.4
Fig.6
Fig.7
Fig.10