Exquisit Gutfels HR 32007 sw Manual Del Propietário página 19

14. To avoid fire or shock hazard, plug the unit directly into a 220-240VAC electrical
outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly
on the plug, DO NOT unplug by pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in
use.
17. Use only for intended household use as described in this manual. Any other use not
recommended by the manufacturer may cause fire
persons. The use of attachments not recommended or sold by unauthorized dealers
may cause hazards.
18. Always use on a dry, level surface.
19. DO NOT use outdoors.
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with
any solid-state speed control device.
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this
unit. Doing so will void your warranty. The inside of the unit contains no user
serviceable parts. Qualified personnel should perform all servicing only.
(*) Competent qualified electrician: after-sales department of the producer or
importer or any person who is qualified, approved and competent to perform this
kind of repairs in order to avoid all danger. In case of need you should return the
appliance to this electrician (www.ggv-service.de).
The instructions for room heaters without a built-in room thermostat or thermal
control limiting the room temperature shall include the substance of the
following:
WARNING:This heater is not equipped wth a device to control the room
temperature. Do not use this heater in small romms when they are occuped by
persons not capable of leaving the room on their own, unless constant supervision
s provided.
The height of the caracters, measured on the capital letters, is at least 3 mm.
These insturctions are also available in an alternative format, e.g. on a website.
The appliance being in very possible position during the test.
The force on the probe in the straight position is increased to 10 N when probe 18
is used.
, electric shock, or injury to
18
ENG
(IEC 60335-2-30)