Menu Operations - NEC 45XR5 Manual De Funcionamiento

OSM
(On Screen Menu)

Menu Operations

The following describes how to use the menus and the
selected items.
1. Press the MENU/ENTER button on the remote control to
display the MAIN MENU.
MAIN MENU
PICTURE
AUDIO
IMAGE ADJ.
SEL. MENU/ENTER OK
2. Press the cursor buttons L M on the remote control to
highlight the menu you wish to enter.
3. Press the MENU/ENTER button on the remote control to
select a sub menu or item.
PICTURE
PICTURE MEMORY
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
NR
COLOR TEMP.
CINEMA MODE
PICTURE MODE
SEL. ADJ. MENU/ENTER
4. Adjust the level or change the setting of the selected item
by using the cursor buttons
CONTRAST
5. The adjustments or settings are then stored in memory.
The change is stored until another change is made.
6. Repeat steps 2 – 5 to adjust an additional item, or press
the EXIT button on the remote control to return to the
main menu.
* When adjusting using the bar at the bottom of the screen,
press the or button within 5 seconds. If not, the current
setting is stored and the previous screen appears.
Note: The main menu disappears by pressing the EXIT
button.
Controls
SET UP
FUNCTION
SIGNAL INFO.
EXIT EXIT
: OFF
: 52
: 32
: 16
: 32
: 32
R G
: OFF
: MIDDLE
: ON
: NORMAL
OK EXIT RETURN
on the remote control.
: 10
En-17
Information
Advanced menu mode
When "ADVANCED OSM" is set to "ON" in the
FUNCTION menu, full menu items will be shown.
PICTURE
PICTURE MEMORY
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
NR
COLOR TEMP.
CINEMA MODE
PICTURE MODE
GAMMA
LOW TONE
SET UP LEVEL
COLOR TUNE
SEL. ADJ. MENU/ENTER
* The actual screen may be different from the ones in
this manual.
: OFF
: 52
: 32
: 16
: 32
: 32
R G
: OFF
: MIDDLE
: ON
: NORMAL
: 2.2
: MODE1
: 0%
OK EXIT RETURN