Before The First Use - Linea DOMO DO9220IB Manual De Instrucciones

PARTS
1. Water tray
2. Freeze fingers
3. Ice shovel
4. Full basket sensor
5. Transparent lid
6. Ice basket
7. Water tank
8. Drain hole with plug
9. Compressor
10. Control panel
CONTROL PANEL
11. Indicator light 'ice basket full'
12. Indicator light 'water reservoir empty'
13. Indicator light 'in operation'
14. On/off button

BEFORE THE FIRST USE

· Make sure all packaging materials and promotional stickers have been removed before using the
appliance for the first time.
· Before using the ice cube maker for the first time: wait 2 hours after putting the appliance in place and
leave the lid open for at least 2 hours.
· Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked.
USE
1. Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked.
2. Open the lid and take out the ice basket so you can pour water into the water tank. It is
recommended to use spring water or mineral water.
! Caution: Make sure that the water level is lower than the maximum indication. If the water tank
is filled above the MAX indication, drain the excess water through the drain hole at the bottom of
the ice cube maker. Open the drainage hole on the underside of the appliance above a collecting
container or a sink.
3. Place the basket back into the appliance and close the transparent lid.
4. Plug the power cord into a socket. The 'in operation' indicator light will start flashing. Press the on/
off button on the appliance to turn it on. The indicator light comes on and the ice-making cycle
starts.
5. Clean the appliance after each use. Empty the water reservoir before storing the appliance. Open
the drainage hole on the underside of the appliance above a collecting container or a sink.
www.domo-elektro.be
1
4
5
6
10
11
12
13
14
2
3
7
9
8
23
DO9220IB