! During the first 3 cycles, the ice cubes may be smaller and more irregular in size. When the ice basket
is full, immediately remove the ice from the ice basket.
●
If the 'water reservoir empty' indicator lamp lights up, there is not enough water left in the water
ADD WATER
reservoir. Fill the water reservoir with water and press the on/off button to restart the machine.
●
If the 'ice basket full' indicator light flashes, the machine will stop working. Empty the ice basket.
If there is no more ice near the sensor, the appliance will restart automatically.
ICE FULL
CLEANING AND MAINTENANCE
·
Switch off the appliance and unplug before cleaning. Also remove
all ice cubes.
·
Drain all water from the water tank through the drain hole at the
bottom of the ice cube maker. Open the drainage hole on the
underside of the appliance above a collecting container or a sink.
·
Regularly clean the ice basket, the water tank, the water tray, the
freeze fingers and the ice shovel. Use a damp cloth, maybe with a
little mild detergent, to clean the inside and the outside of the ice
cube maker. Rinse thoroughly before using the appliance again.
·
Do not use any chemical products or products containing acids,
gasoline or oil.
·
Do not use any mechanical appliances or other aids to speed up
the freezing process.
·
Replace the water in the water tank at least once a day to
guarantee clean ice cubes. When not using the appliance, always
drain the water from the water tank. Always use clean water when
using the ice cube maker.
DESCALING
Descale the appliance regularly to avoid calcification and to maintain a well operating appliance. Use a
descaling product for for example coffee makers, or use a solution of 1/2 vinegar and 1/2 water.
Fill the water tank with the product/solution (do not exceed the maximum level) and switch on the
appliance. The appliance will now pump water into the ice tray. Wait until the tray is filled with water (the
supply of water to the tray will stop) and immediately press the ON/OFF button. The appliance switches
off and will release the product/solution from the ice tray. Repeat this cycle a few times with the descaling
product/solution. Afterwards, fill the water tank with clean water and repeat the procedure until the smell
of the descaling product/solution has disappeared completely.
24
DO9220IB