Mounting The Monitor; Operating The Monitor - Sensitech TempTale GEO LTE Manual Del Usuario

TempTale
Front of Housing
1. Light Sensor
2. Status LED
3. Error LED
4. Start Button
5. Status Button

Mounting the Monitor

• The preferred mounting position is to place the device on top of a pallet. To do this, peel off the protector from the
double sided sticky pad and attach the monitor to the mounting surface.
• An alternative mounting method is to use a tie-wrap.

Operating the Monitor

1. Determine monitor status:
STATUS
• Press the
• The STATUS LED will indicate the monitor's status.
• 4 blinks = NOT STARTED (monitor ready to be started)
• 2 blinks = RUNNING (monitor has already been started)
• 1 blink = STOPPED (monitor has stopped and cannot be started)
STATUS
• The button may be pressed multiple times.
2. Starting and using the monitor:
START
• Press the button for 1 second.
• The STATUS LED will blink rapidly for 30-60 seconds as the monitor powers up.
• Once the STATUS LED stops blinking the monitor is ready to be placed on a shipment UNLESS THE ERROR LED
STARTS BLINKING RED.
• DO NOT USE THE MONITOR IF THE ERROR LED BLINKS RED.
GEO LTE Instructions for Use
®
Tie-wrap
attachment point
button briefly.
Sticky pad
(on reverse side)
3
1
2
3
4
5