Glacier bay 834X-0001 Guía De Uso Y Mantenimiento página 9

Installation (continued)
5
Installing the shower flange,
shower arm, and shower head
□
Insert the long end of the shower arm (B)
through the shower ange (A), then wrap thread
sealant tape around the long end of the shower
arm (B) in a clockwise direction, as shown.
□
Install the long end of the shower arm (B) into
the pipe elbow inside the wall. The shower
ange (A) should t snug to the nished wall
surface.
□
Thread the shower head (C) onto the shower
arm (B).
□
Carefully tighten the shower arm (B) and shower
head (C) with a clean strap wrench. Do not over
tighten, as it could cause damage to the shower
arm (B).
A
B
C
6
Installing the tub spout
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Connect the tub spout outlet pipe (the tub
spout outlet pipe should project 3-7/8 in. to
4-1/16 in. from the nished wall) to the lower
pipe elbow (2, not included). Tighten the
elbows and tub spout outlet pipe connections
with the strap wrench.
□
Thread the tub spout (J) onto the tub spout outlet
pipe in a clockwise direction until the tub spout
(J) becomes ush with the nished wall. Use
a strap wrench to tighten the tub spout (J).
J
9
Please contact 1-855-HD-GLACIER for further assistance.
2
1
3-7/8 in. to 4-1/16 in.
Wall
1
HOMEDEPOT.COM/GLACIERBAY