Changing The Reversible Door - Magic Chef HVDR430WE Manual Del Usuario

CHANGING THE REVERSIBLE DOOR

CAUTION: To avoid personal injury to yourself and/or property, we recommend someone
assist you during the door reversal process.
Your refrigerator is built with a reversible door. You have the choice of either opening it from the left
or the right side. In order to reserve the opening direction of your door, please follow these simple
instructions:
1) Disassemble all the reversible components in the sequence as shown below (also refer to left
diagram above). Be sure to keep them well for later use in the process of reassembling.
(1) leveling leg II
(2) bottom hinge
(3) leveling leg I
(4) bottom door baffle block
(5) 2 screws to hold bottom hinge
(6) door, refrigerator section
(7) mid hinge
(8) 2 screws to hold mid hinge
(9) upper door right stopper
2) To access the bottom hinge assembly, you may tilt back the refrigerator cabinet or lay the
refrigerator on its back.
3) Remove the upper door right stopper (9), install the upper door left stopper (17) on the opposite
side; take down the bottom door baffle block (4), and install it on the opposite side.
4) Reassemble the unit with the door hinges on the opposite side (see the right diagram above).
The sequence for reassembling is just in reverse order of disassembling.
5)
With the mid hinge not being fastened too tight, align two doors properly on the cabinet and then
fasten the mid hinge. If necessary, loosen the bottom hinge and the top
then fasten them tight.
(10) door, freezer section
(11) top hinge
(12) 2 screws to hold top hinge
(13) Tabletop
(14) 2 screws on cabinet rear to hold tabletop
(15) 2 screws to hold tabletop
(16) 2 decorative plugs on tabletop
(17) upper door left stopper
9
hinge when aligning and