Electrical Specifications; Electrical Connection - Twin-Star International TS1500-BLK Manual De Funcionamiento Del Propietario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

HEATER LOCATION

When choosing a location for your new heater,

ensure that the general instructions are followed.

Also, for best effect, install the heater out of direct

sunlight.

Cold climate installation recommendation:

when installing this unit against a

non-insulated exterior wall or chase, it is

mandatory that the outer walls be insulated

to conform to applicable insulation codes.

ELECTRICAL CONNECTION

A 15 AMP, 120 Volt, 60 Hz circuit with a properly

grounded outlet is required. Preferably, the

heater will be on a dedicated circuit as other

appliances on the same circuit may cause the circuit

breaker to trip or the fuse to blow when the heater is

in operation. The unit comes standard with 6 feet

(1.8 m) three wire cord, exiting from the rear of the

heater.

CAUTION: Do not exceed the current rating of the

current tap. Always plug heaters directly into a wall

outlet/ receptacle. Never use with an extension cord or

relocatable power tap (outlet/ power strip).

WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or

rewiring of this unit should be carried out by a licensed electrician in accordance with

national and local codes.

If repairing or replacing any electrical component or wiring, the original wire routing, color

coding and securing locations must be followed.

WARNING: Electrical outlet wiring must comply with local building codes and other applicable

regulations to reduce the risk of fire, electrical shock and injury to persons.

WARNING: Do not use this heater if any part of it has been under water. Immediately call a

qualified service technician to inspect the heater and replace any part of the electrical system.

Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk

of fire, electrical shock or personal injury.

Warning: During any service of this appliance, the power to the unit must be turned off.

First turn the main power switch to the "OFF" position. Then remove the electrical plug from

the wall outlet.

Amps

Watts

Voltage

Keep electrical cords, drapery, furniture and other

combustibles at least 3 feet (0.9 m) from the front of the

heater and away from the sides.

• Tips for using touch-up pen (TS1500-OAK and

TS1500-CHR only): For scratches, stroke in direction

of scratch. For worn areas, stroke in direction of wood

grain. Rub excess colorant promptly with a soft cloth.

• The motors used on the fan and the flame generator

assembly are pre-lubricated for extended bearing life and

require no further lubrication. However, we recommend

periodic cleaning/vacuuming of the fan/heater.

• Make sure the unit is turned OFF and unplugged

whenever you are cleaning the heater.

MAINTENANCE

E-5