Operating Instructions - Pleasant Hearth 23-700-712 Manual De Instrucciones

OPERATING INSTRUCTIONS

The fireplace control functions can be accessed in two (2) ways:
• Using the touchpad control panel, located in the upper right-hand corner of the fireplace
behind the sliding control panel cover.
• Using the multifunction remote control unit.
The fireplace features conveniently separate controls for flame effect and for heater control.
This allows you to operate the unit in two (2) different modes:
• As a full-featured fireplace - both flame effect and heater are on.This mode allows you to enjoy the look
of the fire along with the heat output of a heater.
• As a visual effect - only the flame effect is on, the heater is off. We recommend this mode for warm weather
application, when you want the ambiance of a fire, without any heat output.
3
1
Main Power Button:
This button supplies power to all the functions of the fireplace. The main power button must be
in the ON position, either from the remote or on the touch pad for the functions to work.
2
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature modes from low to high. When the
heater is first turned on, the heater will come on at the lowest room temperature setting. The
fireplace will remember the last heat setting and in later use the heater will start at that setting,
unless power to the unit has been interrupted. Each time the temperature button is pressed, the
temperature set point increases, allowing you to adjust the ambient temperature.
3
Flame Control Button:
This button controls the brightness of the flame effect with settings at high, medium and low.
When the fireplace is first turned on, the flame will come on at the highest setting. The fireplace
will remember the last flame setting used and in later use the flame brightness will start at that
setting, unless power to the unit has been interrupted. Each time the flame button is pressed,
the flame brightness decreases. The only way to turn off the flame effect completely is to
turn off the main power button.
3
2
11
1