ShelterLogic AutoShelter RoundTop 1015 Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. SQUARinG Up THe FRAMe
A. Place frame in its final location, which needs to be as flat and level as possible.
B. Check that the front and rear of the frame measures 10 feet in width.
C. Measure across opposite corners. These distances must be equal to within 1 inch.
8. pRopeRlY AncHoR FRAMe
Your unit comes with 4 temporary Shelter Auger
recommends additional anchors, one for each foot of your frame.
A. Anchors must be placed inside shelter at the corners of the shelter. Insert a ¾-inch pipe or steel rod,
through the eyelet of the auger and screw the anchor into the ground until the eyelet is sticking out of the
ground by 1 to 2 inches so it can be anchored to the legs.
If ground is too hard, dig a hole with a shovel or post hole tool. Optional: Place auger in hole and fill with cement.
B. Thread cable provided through the eyelets of the Anchor as indicated in figure. Secure the cable with the
clamps provided.
10 ft.
Earth Anchors. For best results, ShelterLogic
Page 7
10 ft.
NOTE:
15" Augers are for temporary use only!
For best results ShelterLogic recommends
using our Easy Hooks (#10036 4-pack, #10035
6-pack, or #10038 8-pack) for a stronger, more
secure installation.
End Rib Anchors
Call 1-800-524-9970
or visit
www.shelterlogic.com for
more information.
WARNING:
Serious injury to persons or
property could result if cover
is installed and shelter is
not anchored and is left
unattended. Shelter must be
securely anchored before
use.
05_62689_0C

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

62689

Tabla de contenido