Air Supply - Napa 6-746A Manual De Instrucciones

AIR SUPPLY

Tools of this class operate on a
wide range of air pressures. It is
recommended that air pressure
of these tools measures 90 PSI
at the tool while running free.
Low pressure (under 90 psig/
6/2bar) reduces the speed of all
air tools. Low air pressure not
only wastes time, but also costs
money. Higher pressure (over 90
psig; 6/2 bar) raises performance
beyond the rated capacity of
the tool, which will shorten tool
life because of faster wear and
could cause injury.
LUBRICATION
Lubricate the air motor daily
with NAPA air tool oil. If no
air line oiler is used, run a
teaspoon of oil through the
tool. The oil can be squirted
into the tool air inlet or into
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE. PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
6-746A
Always use clean, dry air. Dust,
corrosive fumes and/or water in
the air line will cause damage
to the tool. Drain the air tank
daily. Clean the air inlet filter
screen on at least a weekly
schedule. The recommended
Air Regulator
Knob
the hose at the nearest
connection to the air supply,
then run the tool. The oil plug
is ONLY for adding standard
SAE 10 or 20 grade oil after
repair or maintenance of
3
hookup procedure can be
viewed in the above figure.
The air inlet used for
connecting air supply, has
standard 1/2" NPT American
Thread. Line pressure should
be increased to compensate
for unusually long air hoses
(over 25 feet). Minimum hose
diameter should be 1/2" I.D.
and fittings should have the
same inside dimensions and be
tightly secured.
Air Inlet
the impact mechanism. The
amount of oil to be used is
1 ounce. Overfilling will cause
a reduction in the power of
the tool.
Rev. 05/27/05