Remote Control - Pur Line Hoti M70 Manual De Usuario

REMOTE CONTROL

1) Set time
Set the time before turn the heater on.
Press "LOCK" on remote control, LED display shows 00:00 and "Mo" light is on.
HOUR: Press "Set" button, first "00" flashes, press
MINUTE: Press "Set" button again, second "00" flashes, press
WEEK: Press "Set" button again, "MO" light flashes, press
Note: When the "Set" key is pressed, the numbers flash on the display for 5 seconds, you must operate at this
time, or the unit will return to standby mode.
2) General Use
1. Switch on the appliance by pressing the main ON/OFF button, the appliance starts in fan mode and
light is on.
2. Press "MODE" button, the device will blow warm air and
3. Press again "MODE" button, the device will blow hot air and
4. Press "MODE" button third time, the device will blow cold air and "Fan/M" light is on.
On control panel: press
2000W; 4th press = oscillation function; 5th press = off.
3) 24H TIMER
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
The button on the control panel and the "24h" button on the remote control have the same function.
2. Press the button
indicator "D" lights up.
Note: "00" means no timer, "D" indicator is off.
4) THERMOSTAT (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
2. To adjust temperature, press
panel light on.
3. When the air temperature drops 2 degree below the set temperature, the heater will start heating with
"I/W"(1000W).
4. When the air temperature drops 4 degree below the set temperature, the heater will start heating with "II/H"
(2000W).
5. When the air temperature is 1 degree more or equal to the set temperature, the heater will blow cold air.
5) WEEK TIMER (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
1- ON/OFF: Main power button
2- 24H:
3- MODE: 3 modes - COLD, WARM, HOT
4- Swing: Louver swing up and down
5. LOCK:
6- AUTO: Open Window Detection
7- Tem.:
8- Delay: Set the turn on/off time of heater
9- W.Timer: Set the timer of one week
10- + :
11- - :
12- Set:
The remote control uses Lithium battery CR2025 3V (not included).
Do not allow children to play with the remote control.
The battery must be removed from the remote control before it is discarded.
The battery must be disposed of safely.
button --> 1st press = fan mode; 2nd press = warm air 1000W; 3rd press = hot air
to set the timer. Continue pressing
"+"
-
o " " , to set the desired temperature, from 10ºC to 49ºC, with the control
Setting timer from 1-24 hours
Child-Lock function for heater
Display room temperature
Increase
Decrease
Set current time
"+"
-
o " " to set the Hour from 01--00 (24h).
"+"
-
o " " to set the minutes from 00--59.
"+"
-
o " " to set the week from Mo--Su (Monday-Sunday).
and
and
button to increase the hours from 00--24, the
11
lights are on.
lights are on.