Publicidad
Idiomas disponibles
Idiomas disponibles
FROM BENDIX
5.43
Ask These Questions:
1. Are all water ports 1/2" NPT?
2. EL1300 and EL1600 all 1/2"?
3. Will additional lines and fittings be required to relocate
governor?
4. Will additional water lines and fittings be required for
installation?
Optional Installation Choices:
1. Remote mount governor.
2. Remote mount air cleaner.
3. Head can be rotated 180°.
Installation Materials that Must be
Supplied:
1. If top discharge, supply SN3711J Manifold Kit.
2. If top head clearance is a problem, supply SN371 1K or
SN3711L (low profile) or SN3711AH (side outlet)
Discharge Manifold Kit.
3. Might need 1/2" to 3/8" water port reducers.
Installation Material that Should be
Considered:
1. For ease of installation and extended life of the compressor ,
use the KN17500 Series Flexible Teflon Discharge Line Kit.
2. Let the compressor breathe. Use a KN19040 Heavy-Duty
Filter.
3. Universal Waterline Changeover Kit SN3502 to hookup
coolant lines.
Installation Material that Might be
Required:
1. Remote Mount Governor Kit SN4011F.
EL1300
12.0
Compressor Installation
Install the compressor to the engine using the supplied gasket.
Care should be taken so no gasket sealant plugs the oil drain.
Assemble the intake manifold, exhaust manifold, and
governor to the compressor using the gaskets provided with
the compressor.
Reconnect the intake, exhaust, oil, and water lines. W ater
must enter the block or head of the compressor and exit the
head at the opposite end.
Close all air and water drain fittings. Fill the engine cooling
system.
Start the engine and check for air, oil, or coolant leakage.
Correct any leakage problems as required.
Check the governor function. Observe the cut-out pressure
(maximum system pressure). Cycle the brakes until the
compressor starts pumping. Observe the system pressure.
The most common pressure range is about 105 psi minimum
system pressure to 125 psi maximum system pressure.
Readjust or replace the governor, if required.
TO HALDEX
.86
10.65
Compressor Illustration
EL13300
5
8
10
9
7
4
3
B
6
2
1
A
Oil
Drain
Item
Description
1
Elbow 1/2" ...................................................b
2
Hose Fitting 1/2" Pipe to 1/2" Hose ............b
3
Hose Clamp ................................................b
4
Water Hose 1/2" ID .....................................b
5
Hose-to-Hose Coupling 1/2" .......................b
6
Manifold Gasket 102368BZ ..................a & c
7
Manifold Lockwashers 35W51020 ..............c
8
Manifold Bolts 08W12028 ...........................c
9
Discharge Manifold 100691C ......................c
10
Discharge Line ............................................d
11
Pipe Plug 1/2" 7 x 107 ................................a
A
Intake Manifold Mounting Flange
B
Governor Mounting Flange
Comment Key:
a
Provided with Compressor
b
Part of SN3502 Kit
c
Part of SN3711 Kit
d
Order from Haldex
EL13300X
3
2
1
11
Oil Feed
Comment
Publicidad
