Powerfix Profi PBMP 30 A1 Instrucciones De Uso página 29

GB/MT
µ
Now push the pump
projects into the thread of the drive shaft
y
are located in the reception holes on the pump
µ
u
Let the drill
and then guide the pump
e
shaft is thereby secured to the pump
µ
Attach the suction hose to the connection
a
connection
q
pump .
When using a chuck with SDS fitting and the long drive
shaft r ...
µ
Attach the long drive shaft
µ
Insert the electric drill
chuck, into the mounting
µ
Tighten the cross-headed screw on the mounting
cannot jolt around.
µ
Now push the pump
projects into the thread of the drive shaft
y
are located in the reception holes on the pump
µ
Allow the electric drill
ons and guide the pump
r
drive shaft
µ
Attach the suction hose to the connection
a
connection
q
pump .
q
onto the mounting
start to run in a clockwise rotation and at low revolutions
q
straight onto the drive shaft
. Pay heed to the direction of flow
r
into the chuck.
u
, with the pre-assembled drive shaft
y
.
q
onto the mounting
u
to run with a clockwise rotation and low revoluti-
q
straight on to the drive shaft
will be fixated onto the pump
. Pay heed to the direction of flow
y
so that the drive shaft
w
, and the pins of the mounting
q
.
o
and the pressure hose to the
y
firmly, so that the drill
y
so that the drive shaft
w
and the pins of the mounting
q
.
o
and the pressure hose to the
- 26 -
q
.
e
. The drive
detailed on the
r
in the
q
.
r
. With this the
detailed on the
e
u
r