Axxess GMOS-LAN-04 Instrucciones De Instalación página 5

Note: If Y91 is present on the RPO list, refer to your owner's manual to adjust chimes.
1) With car on, shut off car and leave keys in ignition. Open
the car door and leave it open. Chimes will be heard.
2) Wait 10 seconds, then with a small screwdriver adjust
the potentiometer fully counterclockwise (all the way left),
then clockwise to raise chime level and counterclockwise
to lower the chime level.
3) When the volume is at the desired level, remove the keys
from the ignition. This will lock the chime volume at its
current level.
1) Start your vehicle and turn on the radio having audio playing.
2) Turn your aftermarket radio's volume up ¾ of the way.
3) With a small screwdriver adjust the potentiometer clockwise to raise the audio level and
counterclockwise to lower the audio level.
4) Once at desired level your audio adjustment is complete.
To adjust the OnStar volume level find the Black/Yellow wire on the 16-pin harness. Push
the blue OnStar button, while the voice is speaking tap the Black/Yellow wire to ground.
There are 4 volume settings for OnStar; once the 4th setting is reached and the Black/
Yellow wire is tapped to ground it will automatically go back to the first volume setting.
Once the volume is set it will stay at that volume until the Black/Yellow wire is tapped to
ground again. This can be set during installation and then left alone. If user adjustment is
desired, the customer may also tap volume up or down on the steering wheel (if equipped)
to adjust the OnStar level.
This 12-pin harness is to be used in conjunction with the ASWC (not included).
Please refer to ASWC instructions for programming.
GMOS-LAN-04
Chime Volume Adjustment
Audio Level Adjustment
OnStar Level Adjustment
Additional 12-pin harness (ASWC harness)
Potentiometer located on 16 pin
side of the interface
5