Columbus TA 50 K 50 Manual De Instrucciones página 13

Knob to regulate
the water-flow
Knob to regulate
the pressure of
the vacuum head
Knob to regulate
the pressure of
the brush
1. To wash carpet, use the standard vacuum head for carpet.
2. Regulate the pressure of the vacuum head on carpet.
3. Regulate the height from floor of the rotating brush, so that you obtain more or less strength in
the action of the rotating brush on the carpet. To lower the brush you must pull the knob located
in the lower rear part of the machine and turn it counter-clockwise. To lift the brush, you must turn
it clockwise. We recommend you to lift completely the brush after finishing the work and before
storing the machine, in order to avoid its damage.
For carpet cleaning, the position generally used is the second-last one
Attention: The brush motor is protected from overload, by a protection located on the control panel. If
this protection intervenes, it is necessary to reduce the pressure of the brush, to avoid the overload of
the motor. If this is not enough to avoid that the protection repeatedly intervenes, you should contact
the technical assistance. The repeated intervening of the protection might result in faults which cannot
be covered by warranty.
4. Lower the vacuum head by pushing on the rudder bar, which is situated on the right-lower side of
the machine.
Attention: Keep an adequate safety distance from other people, who could be run over by the
machine. Pay attention to any object that could be hit by the machine.
To switch on the machine you must act on the switches on the control panel:
Use as a Self-contained Machine
13
TA 50│K 50
Rudder bar to
lift and lower
the vacuum head