ACDelco ARM602-4 Manual Información Del Producto página 10

NOTE
1. When you are approaching -10% units before the target torque value, an
intermittent buzzer will start to warn you.
2. When the target torque value is reached, a high-frequent buzzer will warn you
not to pull further.
MEMORY FUNCTION
The system will memory the "mode" and "unit" selection which you set even you
change coin cells.
RESET MEMORY FUNCTION
To clean the memory, just press the "Down Button (4)" and "Up Button (5)" together
for 2 seconds.
COUNT FUNCTION
Just press the "Power Button (3)" and "Up Button (5)" together to show how much
times this adapter has been used.
NOTE
The system will record this time automatically when the torque value
reaches the target torque value you set. The counter unit is thousand as shown "K",
and the maximum is 999K.
OVERLOAD ALARM/RECORD
The system will show "Err" on the display if the torque exceeds 110% of the maximum
torque, and a high-frequent buzzer will warn you not to pull further. After that the
"Err" will be shown for 1 second every time when you power on this adapter.
NOTE
Overload will damage this adapter and lose its accuracy. Please return
this adapter to an authorized service center to calibrate it and eliminate the "Err".
AUTO POWER OFF
This adapter will be shut off automatically after 60 seconds of non-use.
HOW TO USE AS A TORQUE WRENCH
Connecting the adapter to ratchet wrench, and socket.
INCORRECT OPERATION
The torque or force only applies on the driver head. Never apply extra torque or
force on the place other than the driver head.
1English1
English -9