Installation
FAUCET INSTALLATION
- Remove the gasket (3), metal washer (4), and retaining nut (5) from the faucet shank.
- If you are installing this faucet onto a 3 hole sink, remove the faucet base (2) and ensure the
base o-ring (1) is well seated in the grove at the bottom of the faucet. Use the decorative cover
plate (C) to cover the extra faucet holes. Otherwise skip this step.
- Feed the faucet hoses through the faucet mounting hole .
Cover
Plate (C)
3-Hole Sink Installation
- Secure the faucet to the sink with the
gasket (3), metal washer (4), and retaining
nut (5) from underneath.
- Tighten the retaining nut (5) by hand until it
is snug. Gently tighten the two screws (6) in
the retaining nut . Do not overtighten .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Faucet Base (2)
Remove
Base
O-ring (1)
Sink
Fig . 1
5
1-Hole Sink Installation
Gasket (3)
Retaining Nut (5)
Fig . 2
Base O-ring (1)
Faucet Base (2)
Sink
Sink
Metal Washer (4)
Screws (6)
CONGLOMKB .COM