Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TODO en 1 / ALL in one: UNI-500
on),Then please return to step C.
I.
Try if keys on Remote Control work or not. If most keys work improperly, please try other code
under the same brand (For example: code 004,023......under Philips TV),repeat A～E Till you
find the main keys work good enough.
Remark:
A. In the process of setup ,if you want to quit from set up mode, please press the device key.
B.
If no key is pressed in 10 seconds the remote control will leave the setup mode automatically.
2. Set up By Manual Search:
If you have used all the codes under the brand name, the remote control still does not work(i.e. the
device still can not be controlled by this remote control),or you can not find the correct brand in the
Device Code List, you can use Manual Search to find out the correct code.
C.
Power on the device that you want to control. If it is a VCR/CD/LD/VCD/DVD, it must be
inserted with a tape/disk.
D.
Press and hold [SET] key and press the device key(TV1 etc)at the same time.
E.
The LED will be on at the moment.
Then release the pressed both keys.
F.
Press the [SET] key again, then release it, The remote control enters into Manual Search Mode
and the LED keeps flashing.
G.
Point the remote control to the device, and then press and release the [POWER] key slowly.
See if the device reacts or not. If it reacts, turn to step F .If not ,repeat step E(press the
[power])every 1 second.
H.
Test other keys, if they do not work good enough, return to step A.
Remarks:
A . Because Some device work slowly for the POWER signal, In search process, you can press[SET]
key to switch between Forward and Backward to change search direction and find the right code
quickly.
E.
Whenever you want to leave search mode, press the device key, and the LED will turn off.
F.
In the search mode, besides the [POWER] key, all other key's function can be checked normally,
That is to say you can test other keys without leaving search mode.
G.
The remote unit will leave search mode automatically if no key is pressed in 30 seconds.
3. Set Up By Auto Search:
This search is similar to Manual Search but the remote control transmit the power signal
automatically instead of manually pressing power key.
D.
Power on the device you want to control. if it is a VCR/CD/LD/VCD/DVD, it must be inserted
with a tape/disk.
E.
Press and hold [SET] key, in the meantime, press and hold the[POWER] key for more than 3
seconds and then release them, the auto search begin. The remote control enters into Auto
Página 8
Publicidad
Tabla de contenido
